GLEASON 519 UNIVERSAL TESTER

Gleason Universal Bevel Gear Tester
Model # 519 
s/n 652701

 Model No. 519 GLEASON Universal Angular Hypoid Bevel Gear Tester for testing the
               the running qualities of bevel, hypoid, spur and helical gears up to 24” (610mm) diameter
               from 0 to 180 degree shaft angle and up to 36” (914mm) diameter at 90 degree shaft angle 

       Serial  No. 652701? will advise

The machine corresponds to the attached copy of factory literature, featuring the following:

PRINCIPAL SPECIFICATIONS

Maximum diameter of bevel gear at 90 degree shaft angle .......... 36"    (914mm)
Maximum diameter of bevel pinion at 90 degree shaft angle ....... 12"    (305mm)
Maximum offset of gear spindle above 
  or below pinion spindle center ........... ................................... 6"    (152mm)
Shaft angle range .................................................................. 0 to 180 degrees
Maximum diameter of parallel shaft gear
  w/angular head setting w/max. offset ...................... ………… 49"    (1245mm)
Maximum diameter of parallel shaft pinion
  w/angular head setting w/max. offset .................................... 25"    (635mm)
Maximum center distance ..................................................... 25"    (635mm)
Minimum center distance ..................................................... 0" (0.0mm)
Pinion spindle taper hole diameter (at large end) ………….. 6” (152.4mm)
Pinion spindle taper (per ft.) …………………………………… .75” (19.05mm)
Pinion spindle taper depth ……………………………………… 3” (76.2mm)
Gear spindle taper hole diameter (at large end) ……………… 3.9” (99.21mm)
Gear spindle taper (per ft.) …………………………………….. 0.618” (15.47mm)
Gear spindle taper depth ……………………………………….. 3” (76.2mm)
Main motor ........................................................................ 5  HP 1800 rpm
Hydraulic motor ………………………………………………… ¾ HP 1800 rpm
Machine overall length …………………………………………. 90” (2286mm)
Machine overall width ………………………………………….. 75” (1905mm)
Machine overall height ………………………………………… 72” (1829mm)
Approx net weight .......................... ………………………… 10,555 Lbs. (4,798 kGs)

Machine is set up for manual clamping only and is not equipped with hydraulic clamping

Machine can be inspected in our statesville NC facility with proper Notice

we are not gleason experts however these are machine catalog specifications and we recommend that you inspect the machine prior to purchasing to confirm all information is accurate